Bluesint PA 12

Hollowing

If possible, try to hollow out your part. This avoids deformation and discoloration during the printing process. You can either hollow out your part without a surface hole, which means that unsintered powder will remain trapped inside, or you can design a strategically placed hole (two would be even better) so that the unsintered powder can be easily removed after printing. If the part needs to be reclosed, design a lid with a diameter allowing for 0.5 mm play between the part and the lid. 

If your part has walls thicker than 9 mm, our production team may hollow out the part to prevent deformation and discoloration. For parts with wall thickness higher than 15 mm wall thickness, this is done by default. In that case, the powder will stay trapped inside. 

Warpage and deformities

We strongly recommend that you do not design large, flat plains in dimensions like an A4 page. In most cases, your model will deform. This process is called “warping”. Creating support ribs under your plane does not solve the problem, but rather increases the chance of deformation even more. The key here is to avoid large flat planes.

Interlocking or moving parts

Due to the nature of the material, we do not recommend interlocking or moving parts.

Assembly

When designing parts that need to be assembled, it is important to maintain enough distance between the parts. A perfect fit in your CAD software does not necessarily ensure a perfect fit after printing because your software ignores the friction present in the real world. Therefore, always leave at least 0.6 mm between the different parts. For parts with large surfaces and wall thicknesses, you will need to maintain even more distance between the parts. In cases like these, please get in touch with our team to check printability. 

In order to help us print your parts with the best possible dimensions for assembly, please design your files with an orientation equal to the relative orientation of your parts in the final assembly.

Embossed and engraved details

For engraved text or surface details, we recommend letters with a minimum line thickness of 1.5 mm, a depth of 0.5 mm, and an overall height of at least 8 mm. Embossed text or surface details should be thick enough that they will not break during production or transport. We recommend letters that have a line thickness of at least 1.5 mm, an overall height of at least 8 mm, and a depth of at least 1 mm.  

Holes and channels

Holes with a small diameter are exposed to a lot of heat during the sintering process. This can cause the powder inside the holes to become fused. To make sure that holes in your parts remain clear, design a diameter of at least 3 mm. 

Longer internal channels can be difficult to clear out, especially if the powder is partially sintered together. We recommend a diameter of at least 5 mm for internal channels. In the case of complex channel geometries with several turns, please get in touch with our team to check printability.