Tutorial video

Automatic file repair in Materialise Magics

This tutorial explains how to fix STL file errors in order to successfully 3D print models.

 This tutorial has been recorded using Materialise Magics. Some features might differ from the Materialise Magics Essentials software.

Prerequisites

Video topics

No time to watch the complete video? Jump to the topics of your interest. Have a look at the time stamps below.

Automatic fixing 0:33

Fix wizard 1:43

Fix wizard-combined fix 2:56

Manual fixing 3:18

Description of the different steps

  1. Select your part(s).
  2. For automatic fixing, go to the Fix >> AutoFix. You can monitor the status of your part from the Part Pages >> Part Fixing Info. If needed, do a second run of automatic fixing.
  3. For semi-automatic fixing, go to the Fix >> Fix Wizard. The Fix Wizard allows you to control the fixing steps. There are pages dedicated to fixing specific error types, and the wizard will give you advice that you can follow by clicking on Follow Advice. Alternatively, you can do a Combined Fix, which allows you to leave out certain fixing steps to do them manually. You can always refer to the Diagnostics page to follow the status of your part.
  4. For manual fixing, you can either use the tools available in the Fix ribbon, or you can use the options under Manual in the Fix Wizard pages.
Author(s) Aylin Kertik
Tutorial created on 05 April 2017
Last modified on 23 April 2018